Two way passive, full range open back 6” ceiling speaker
- 6” Coaxial Driver
- Discreet size without back can
- Unobtrusive Design
- 16 ohm or 70/100V line operation
- Wide Conical Coverage Pattern
- Integrated Mounting Hardware
Bars/Restaurants & Cafes
Houses of Worship
Up 6O is a discreet 6” ceiling speaker delivering consistent coverage and crisp, clear sound to a wide range of cost conscious, commercial environments from hotels and concourses to retail outlets, bars and restaurants.
Up 6O is supplied without a back can for ceilings with a minimum cavity depth, while an integral fixing system is included to achieve a simple and clean installation. The steel perforated grille is finished in neutral white.
Up 6O features a 6” (162mm) low frequency driver paired with a 0.7” (20mm) metal dome tweeter. It is suitable for both high quality speech and music reproduction. A conical 110° coverage pattern delivers consistent, high performance sound where it needs to go.
Each Up 6O can be run on a series of 70 or 100 Volt taps or at low impedance. The 16 ohm setting allows up to four units to be connected to each amplifier channel at low impedance. Tap selection is via a rotary switch behind the removable grille.
SmartAmps or Zone will provide optimal performance and loudspeaker protection. When coupled with the Zone series, a ZonePad and the WebApp makes setting up a system and end user control simple and intuitive.
|TYPE||Two-way, full range, passive, ceiling speaker|
|FREQUENCY RESPONSE (with preset)|
65Hz to 18kHz ±3dB
LF: 6.5” (162mm), Coated paper
HF: 1” (25mm) exit/ 0.7” (20mm) Metal dome
|RATED POWER||60W (AES) 120W (Peak)|
|MAXIMUM SPL||108dB (cont), 111dB (peak)|
|RECOMMENDED HIGH-PASS FILTER||24dB/octave @ 60Hz|
|TRANSFORMER TAPS @ 70V||60, 30, 15, 7.5W|
|TRANSFORMER TAPS @ 100V||60, 30, 15W|
|DISPERSION (-6dB)||110˚ conical|
|PROTECTIVE GRILLE||Perforated steel|
|CONNECTORS||4 Pin Euroblock with link out|
|FITTINGS||C-ring support backing plate|
DIMENSIONS (inc. Grille)
(Ø) 251mm x (D)103.5mm
(Ø) 9.88” x (D) 4.1”
- 2 tile support rails (for 2 ft or 600 mm tile spans)
- cutout template
- paint shield
- removable locking multi-pin connector